Outer circlip which is mounted on the brake anchor plate to fix the brake pads.
This BZ disk is suitable for the front and rear brake anchor plate of Puch Supermaxi mopeds with Grimeca wheel hub.
Details
| Nominal diameter | 6 mm |
| Fuse type | Inside |
| Manufacturer | Puch |
| Place of use | Brake anchor plate |
Suitable for the following models
| Puch |
Moped fans like you also bought:
Magura gas cable clamp / deco cable clamp Ø 5 x 6 mm
Drive: Slot · Screw head: Lens head · Thread type: M4x0.7 (standard thread) · Manufacturer: Magura · Thread length: 4 mm · Ø Cable bushing: 1.6 mm · Number of components: 2 pcs · Material: Brass · Material: Steel · Surface: nickel-plated · Ø outside: 5 mm · Total length: 6 mm
CHF 2.00
NTN wheel bearing 12/28/8 rear cast hub Leleu | Puch Maxi
Bearing type: Deep groove ball bearing · Stock number: 6001 · Ø inside: 12 mm · Ø outside: 28 mm · Width: 8 mm · Inner ring width: 12 mm · Manufacturer: NTN · Ball bearing closed: Yes · Dust protection type: 2RS - NBR contact seal on both sides · Bearing clearance: CM (special/noise-reduced) · Bearing cage: "-" Sheet steel cage ball-guided · Groove ring: No · Material: Plastic · Material: Steel · Surface: blank · Area of application: Standard
CHF 5.90
swiing® revival wheel axle set M12x1 x 185 cast rear wheel galvanized | Puch
Ø outside: 11.8 mm · Manufacturer: swiing® revival parts · Total length: 185 mm · Material: Steel · Surface: galvanized (blue) · Thread type: MF12x1 (fine pitch thread) · Ø shaft: 11.9 mm · Thread length: 26 mm · Thread length: 52.5 mm · Shank length: 100 mm · Width across flats SW: 19 mm
CHF 14.90
Not in stock
Collection only possible with online purchase and appointment.
