Left fork standpipe for your Puch X30 NS, NL, NG-2AH and Supermaxi LG1 and LG2 moped / moped.
The flat bar for attaching the brake anchor plate is located 30 mm above the center of the wheel axle.
There is a bracket for attaching the mudguard. The distance between the two mounting holes is 36 mm.
Total length: 495 mm
Ø fork leg: 23 mm
Length of mudguard tab: 54 mm
Corresponding attachments for the dip tube such as fork spring, fork bushes, spring insert etc. can be found in the accessories section.
NOS – New from old stock.
Original Puch spare part number: 321.1.30.015.2
Details
| Total length | 495 mm |
| Manufacturer | Puch |
| Material | Steel |
| Surface | chrome-plated |
| Color | Chrome |
| Adjustable | No |
| Ø spars | 23 mm |
| Distance brake cam to wheel axle center-center | 38 mm |
Suitable for the following models
| Puch |
Accessories & related products
Moped fans like you also bought:
NTN wheel bearing 12/28/8 rear cast hub Leleu | Puch Maxi
Bearing type: Deep groove ball bearing · Bearing cage: "-" Sheet steel cage ball-guided · Stock number: 6001 · Inner ring width: 12 mm · Manufacturer: NTN · Dust protection type: 2RS - NBR contact seal on both sides · Bearing clearance: CM (special/noise-reduced) · Groove ring: No · Material: Plastic · Material: Steel · Surface: blank · Width: 8 mm · Ø outside: 28 mm · Ø inside: 12 mm · Area of application: Standard · Ball bearing closed: Yes
CHF 5.90
swiing® revival wheel axle set M12x1 x 185 cast rear wheel galvanized | Puch
Manufacturer: swiing® revival parts · Material: Steel · Surface: galvanized (blue) · Thread type: MF12x1 (fine pitch thread) · Ø shaft: 11.9 mm · Ø outside: 11.8 mm · Total length: 185 mm · Thread length: 26 mm · Thread length: 52.5 mm · Width across flats SW: 19 mm · Shank length: 100 mm
CHF 14.90
Collection only possible with online purchase and appointment.
