Complete ignition with VEC coil and 6 volt light coil for clockwise rotating automatic engines such as those installed on Puch Maxi S, N mopeds / mopeds with E50 engines.
The set includes all parts such as fastening screws, flywheel nut with wedge, ignition plate, ignition and light coil, pole wheel and spark plug connector.
The components are supplied individually and still need to be assembled.
Direction of rotation: Right (clockwise)
Operating voltage of the light system: 6 volts
Wattage of the light system: 17 watts
Ø inside flywheel: 90 mm
Attention: A spark plug connector with at least 10 kOhm discharge must be used, the spark plug must not be discharged!
With Beru or MERIT spark plug connectors, misfiring may occur.
Adjusting the ignition:
In principle, nothing needs to be adjusted on the ignition. Only the ignition plate can be turned slightly for a perfect ignition spark, the rest is regulated by the ignition chip.
In the basic setting, the three fastening screws of the ignition plate are located in the middle of the slotted holes. Pre-tensioning is achieved by turning the ignition plate against the direction of motor rotation. Fine adjustment is carried out at medium speed using the strobe light. The electrode gap on the spark plug must be set to 0.7 - 0.8 mm in advance.
The ignition timing adjustment gun as well as other tools and individual parts for your ignition can be found in the accessories section.
The set includes the following fixed parts:
Manufacturer: GPO · Pony spare part no.: A2133, A5532 · Sachs spare part no.: 0265 140 005, 0265 206 000
Manufacturer: GPO · Material: Steel, Plastic · Tension: 6 V · Performance: 17 W · Direction of rotation: right · Ø cone small inside: 11.5 mm · Ø cone large inside: 15 mm · Cone length: 18.5 mm · Cone ratio: 1:5 · Ø Internal flywheel: 91.1 mm · Ø Flywheel outside: 116.5 mm · Thread type: MF26x1.5 (fine pitch thread) · Thread length: 7 mm · Weight: 900 g · Height: 36.5 mm
Manufacturer: NGK · Material: Plastic, Rubber · Color: black · Ø cable: 5 mm, 7 mm · Spark plug socket: SAE · Cable available: No · Suppressed: Yes · Resistance: 10000 Ω
Manufacturer: GPO · Material: Steel · Surface: blue galvanized · Area of application: Standard · Nut type: Flange nut · Drive: External hexagon · Thread type: MF10x1 (fine pitch thread) · Ø outside: 18.8 mm · Height: 8.9 mm · Width across flats SW: 14 mm · Pony spare part no.: A4513 · Sachs spare part no.: 0942 072 102
Material: Steel · Total length: 9.15 mm · Width: 3 mm · Height: 3.7 mm
Manufacturer: swiing® revival parts · Material: Steel · Surface: blue galvanized · Alternative version of the Puch spare part no.: 900.3202, 900.1509
Tension: 6 V · Performance: 17 W · Ø Internal flywheel: 90 mm · Height: 25.2 mm · Total length: 76.8 mm · Mounting type: Screws · Number of fixing points: 2 pcs · Ø mounting hole: 4.1 mm · Hole spacing: 54 mm · Area of application: Standard, Original
Manufacturer: VEC · Place of use: Internal (in the ignition) · Ø Internal flywheel: 90 mm · Ø cable holder: 5 mm · Cable length: 140 mm, 420 mm · Color: black · Total length: 77 mm · Height: 48 mm · Mounting type: Screws · Number of fixing points: 2 pcs · Ø mounting hole: 4.6 mm · Hole spacing: 54 mm · Area of application: Standard, Original, Performance
Details
Manufacturer | VEC, GPO |
Ø Internal flywheel | 90 mm |
Tension | 6 V |
Ø cable | 5 mm |
Performance | 17 W |
Direction of rotation | right |
Area of application | Tuning, Standard |
Mounting type | Screws |
Suitable for the following models
Puch | E50 |
Accessories & related products
GPO flywheel trigger M26x1.5 / M22x1.5 | Puch, Sachs
Width across flats (trigger): 27 mm · Manufacturer: GPO · Clamping depth: 10 mm · Width across flats Screw: 19 mm · Area of application: (Dis)assembly tool · Material: Steel · Surface: blackened · Number of components: 1 pcs · Total length: 55 mm · Total length: 75 mm · Thread type: MF22x1.5 (fine pitch thread) · Thread type: MF26x1.5 (fine pitch thread) · Strength class: 8.8
CHF 9.90
swiing® ingenious flywheel holder 3 pins (Bosch / Ducati flywheels)
Manufacturer: swiing® ingenious parts · Area of application: Special tool · Material: Steel · Surface: blue galvanized · Surface: rubberized · Number of components: 1 pcs · Total length: 290 mm · Height: 80 mm · Thickness: 5 mm · Diameter: 19 mm · Ø inside: 27 mm · Ø outside: 93 mm · Ø Pin: 8 mm
CHF 47.90
swiing® revival ignition set (Bosch / Ducati / swiing)
Manufacturer: swiing® revival parts · Tension: 6 V · Performance: 17 W · Direction of rotation: left · Direction of rotation: right · Ø mounting plate: 90 mm · Ø Internal flywheel: 90 mm · Ø cable: 5 mm · Number of fixing points: 3 pcs · Area of application: Standard · Alternative version of the Pony Spare part no.: A2656 · Alternative version of Sachs spare part no.: 0283 130 004 · Alternative version of Sachs spare part no.: 0286 254 008
CHF 154.90
VEC electronic ignition coil (replaces ignition coil, capacitor & contact breaker)
Manufacturer: VEC · Place of use: Internal (in the ignition) · Ø Internal flywheel: 90 mm · Ø cable holder: 5 mm · Cable length: 140 mm · Cable length: 420 mm · Color: black · Total length: 77 mm · Height: 48 mm · Mounting type: Screws · Number of fixing points: 2 pcs · Ø mounting hole: 4.6 mm · Hole spacing: 54 mm · Area of application: Original · Area of application: Performance · Area of application: Standard
CHF 99.90
Not in stock
GPO / swiing ignition set breaker clockwise 6V
Manufacturer: GPO · Manufacturer: swiing · Material: Aluminum · Tension: 6 V · Performance: 17 W · Direction of rotation: right · Ø mounting plate: 90 mm · Ø Internal flywheel: 90 mm · Mounting type: Screws · Number of fixing points: 4 pcs · Area of application: Original · Area of application: Standard
CHF 199.90
Not in stock
GPO / swiing ignition set, left-hand breaker 6V
Manufacturer: GPO · Manufacturer: swiing · Material: Aluminum · Tension: 6 V · Performance: 17 W · Direction of rotation: left · Ø mounting plate: 90 mm · Ø Internal flywheel: 90 mm · Mounting type: Screws · Number of fixing points: 4 pcs · Area of application: Original · Area of application: Standard
CHF 199.90
Moped fans like you also bought:
Light coil 6V with cable
Total length: 76.8 mm · Area of application: Original · Area of application: Standard · Tension: 6 V · Performance: 17 W · Ø Internal flywheel: 90 mm · Ø mounting hole: 4.1 mm · Height: 25.2 mm · Number of fixing points: 2 pcs · Hole spacing: 54 mm · Mounting type: Screws
CHF 18.90
GPO flywheel 6V / 17W clockwise (Version 2.0) | Puch E50
Manufacturer: GPO · Weight: 900 g · Material: Plastic · Material: Steel · Ø Internal flywheel: 91.1 mm · Tension: 6 V · Performance: 17 W · Direction of rotation: right · Ø cone small inside: 11.5 mm · Height: 36.5 mm · Ø cone large inside: 15 mm · Cone length: 18.5 mm · Cone ratio: 1:5 · Ø Flywheel outside: 116.5 mm · Thread type: MF26x1.5 (fine pitch thread) · Thread length: 7 mm
CHF 87.90
Not in stock
VEC electronic ignition coil (replaces ignition coil, capacitor & contact breaker)
Manufacturer: VEC · Place of use: Internal (in the ignition) · Ø Internal flywheel: 90 mm · Ø cable holder: 5 mm · Cable length: 140 mm · Cable length: 420 mm · Color: black · Total length: 77 mm · Height: 48 mm · Mounting type: Screws · Number of fixing points: 2 pcs · Ø mounting hole: 4.6 mm · Hole spacing: 54 mm · Area of application: Original · Area of application: Performance · Area of application: Standard
CHF 99.90
Not in stock
Nut M10x1 SW14 Flywheel
Manufacturer: GPO · Material: Steel · Surface: blue galvanized · Area of application: Standard · Nut type: Flange nut · Thread type: MF10x1 (fine pitch thread) · Ø outside: 18.8 mm · Drive: External hexagon · Width across flats SW: 14 mm · Height: 8.9 mm · Pony spare part no.: A4513 · Sachs spare part no.: 0942 072 102
CHF 2.40