Piston clip installation tool for C-shaped retaining rings on your moped, moped and small motorcycle.
This tool enables the installation of 12 mm piston pin retaining clips without eyelets, also known as C-clips, without causing damage to the piston or causing them to fly off.
The locking clip is first inserted into the conical part (bushing) of the tool from behind. The pin is then attached and held against the bore of the piston pin on the piston. The long cylinder can then be carefully pressed into the groove. The use of some lubricant can be helpful.
The suitable alternative for 10 mm KoBo retaining clips can be found in the accessories section.
Quality product from the manufacturer Naraku.
| Manufacturer | Naraku |
| Material | Steel |
| Diameter | 12 mm |
| Total length | 134 mm |
| Surface | burnished |
| Ø Pin | 4.5 mm |
| Area of application | (Dis)assembly tool |
Accessories & related products
Moped fans also bought
GPO 38 mm cylinder head original | Puch Maxi S, N / X30 NS, NL, N-2AH
Manufacturer: GPO · Material: Aluminum · Surface: sandblasted · Ø cylinder: 38 mm · Width: 125 mm · Height: 55 mm · Number of fixing points: 4 pcs · Total length: 135 mm · Candle thread: short · Decompressor: No · Hole pattern [mm]: 44 x 44 · Area of application: Standard
CHF 32.90
Speedometer drive 16" left with grease nipple holder
Ø axle: 11 mm · Ø mounting hole: 11.2 mm · Material: Aluminum · Place of use: left · Color: gray · Wheel size [inch]: 16 " · Ø outside: 42 mm · 4-edge speedometer cable: 1.8 mm · Overall width outside: 48 mm · Thread type: MF10x1 (fine pitch thread) · Total height: 52 mm
CHF 21.90
Hot 
swiing® ingenious "Expert" motor stand
Surface: varnished · Manufacturer: swiing® ingenious parts · Total length: 370 mm · Width: 245 mm · Material: Steel · Color: red · Color: white · Hole spacing: 21.5 mm · Ø Receptacle: 25 mm · Ø Receptacle: 35 mm · Material thickness: 3.5 mm · Height: 340 mm · Area of application: Motor bracket
CHF 74.90
Collection only possible with online purchase and appointment.
